Bob Biloxi
2014-10-15 12:28:55 UTC
Hi All,
I ran into an issue while executing RST2INIT_QP HCR command on mlx4.
The command gets completed, but returns a status 3 instead of 0.
The 3 indicates that the QP number is reserved.
I did allocate ICM for all the QPs. I am using SRIOV mode.
The reserved number of QPs obtained from QUERY_DEV_CAP is 64.
My profile indicates I am using 2048 QPs. so as i understand QP
numbers from 65 to 2047 should not be reserved by the firmware..
Any idea why I am seeing this error?
Please help me debug the same, will be very much grateful to you.
Thanks
Best Regards,
Bob
--
To unsubscribe from this list: send the line "unsubscribe linux-rdma" in
the body of a message to majordomo-***@public.gmane.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
I ran into an issue while executing RST2INIT_QP HCR command on mlx4.
The command gets completed, but returns a status 3 instead of 0.
The 3 indicates that the QP number is reserved.
I did allocate ICM for all the QPs. I am using SRIOV mode.
The reserved number of QPs obtained from QUERY_DEV_CAP is 64.
My profile indicates I am using 2048 QPs. so as i understand QP
numbers from 65 to 2047 should not be reserved by the firmware..
Any idea why I am seeing this error?
Please help me debug the same, will be very much grateful to you.
Thanks
Best Regards,
Bob
--
To unsubscribe from this list: send the line "unsubscribe linux-rdma" in
the body of a message to majordomo-***@public.gmane.org
More majordomo info at http://vger.kernel.org/majordomo-info.html